The right garden fence depends on how much privacy you need, how exposed the site is and what you want to spend. Lap panels are the cheapest way to get privacy, closeboard is stronger and lasts longer, and picket or post and rail suit low boundaries at the front. In England, most garden fences can be up to 2 m high without planning permission, or 1 m next to a highway used by vehicles. This short guide compares the main fence types, looks at how feather edge boards are used, and shows how to choose.The main types of garden fence
Five types cover most UK gardens: lap panels, closeboard, hit and miss, picket and post and rail. Privacy and cost separate them most.
| Type | Privacy | Best for |
|---|---|---|
| Lap panel | Good to high | Sheltered gardens and budget privacy |
| Closeboard | High to full | Back gardens where privacy and strength matter |
| Hit and miss | Good | Contemporary gardens and dividing areas |
| Picket | Little or none | Front gardens and marking off areas |
| Post and rail | None, open rails | Front gardens and long boundaries |
Lap panels
Lap panels are horizontal boards that overlap on a frame. They give good to high privacy at one of the lowest prices, and they can be painted to match a garden. They are less strong and long lasting than closeboard and need regular upkeep, so they suit sheltered gardens and tight budgets. Ready-made panels are typically 1.83 m (6 ft) wide and come in heights of 3, 4, 5 and 6 ft (0.91 to 1.83 m).
Closeboard
Closeboard uses vertical boards on a heavier frame, with no gaps between them. It gives high to full privacy and costs more than a lap panel. It needs regular staining, and 1.8 m (6 ft) is the most common height. It comes as ready-made panels, or it can be built on site one board at a time.
Hit and miss and slatted fences
Hit and miss fences have boards fixed alternately on each side of the rails, so the fence looks the same from both sides and lets some air through. Double-slatted styles give good privacy, but they cost more and are hard to paint or stain. Single slatted fences leave gaps, so they give less privacy, and weeds can grow through the gaps. These styles suit contemporary gardens and dividing a garden into zones.
Picket and post and rail fences
Picket fences have spaced vertical boards and are normally low. They give little or no privacy or security, so they are not ideal for pet owners, but they suit front gardens, ponds and marking off areas. Post and rail fences are open, strong enough to run over long stretches and look good at the front of a house.
How a timber fence is built
The parts of a garden fence
Every timber fence has the same basic parts, whatever the style. Posts carry the weight of the fence and the wind load on it. Rails are the horizontal timbers that the boards are fixed to. Arris rails have a strong triangular section, while cant rails are weaker and are nailed straight onto the posts. A short centre stump under a long rail stops it sagging.
A gravel board runs along the bottom to keep the panels off damp soil. Capping on top of the boards keeps water out, with counter rails behind it, and post caps protect the tops of the posts and finish the look. For a closeboard fence, use posts of at least 100 x 100 mm and place them no more than 3 m apart.
Feather edge timber
Closeboard fencing is built from feather edge timber, boards that taper so one edge is thicker than the other. The thick edge of each board overlaps the thin edge of the next, which leaves no gaps and gives full privacy. Boards are commonly 125 mm wide.
The boards run vertically and are nailed to horizontal arris rails, which sit in notches or mortices cut in the posts. Use two rails for a fence up to 1.2 m high and three for anything taller. Nail through the thick edge into each rail with 40 mm galvanised nails. The overlap is usually about 25 to 40 mm, and it should stay the same along the whole run.
Because the fence is built board by board on site, it can follow changes in ground level, and a damaged board can be replaced on its own, which is easier if the boards are screwed rather than nailed.
Timber or concrete posts
The choice comes down to a few differences:
- Cost: timber posts typically cost 30 to 40 percent less than concrete ones.
- Rot and lifespan: concrete posts do not rot. Timber posts must be pressure treated for ground contact, because the buried part is where rot starts. Correctly treated timber posts can last as long as concrete ones, while dip-treated posts are likely to fail after a few years.
- Weight: a 2.7 m slotted concrete post can weigh around 52 kg, so it is a job for two people, while timber posts are easier to install and handle.
- Wind: concrete posts can withstand strong winds.
- Fixing: panels and gravel boards slide in between slotted concrete posts, whereas panels are screwed to timber posts with clips.
Wind, slopes and upkeep
Wind and exposed gardens
Wind is the main test of a fence. Open styles such as picket and slatted fences let wind pass through, which reduces the pressure on them. Solid panels catch more wind, so in an exposed garden they need strong posts set deep and a sturdy frame. Closeboard, with its heavier frame, is generally the stronger solid option.
Set posts at least 600 mm into the ground. A common rule is to bury about a third of the post, which is around 800 mm for a 2.4 m post.
Sloping ground
On sloping ground, cut a gravel board to fill the angled gap under each panel, or build a low retaining wall under the fence. A fence built board by board on site can follow the ground more closely than ready-made panels.
Treatment and upkeep
Pressure-treated timber is far more effective than dip-treated timber. A dip gives only basic protection and colour, so dip-treated timber should be treated as soon as possible and then again, often every year. Pressure-treated timber needs no re-treatment, although an occasional coat of stain or sealer helps.
Treat any cut end with wood preservative, because sawn timber is unprotected. A well-installed pressure-treated fence typically lasts 10 to 20 years, and longer with high-quality timber. The main threat is moisture at ground level, so keep the boards off the soil with a gravel board and keep the posts firm.
Tighten loose fixings early and replace a damaged board as soon as you see it. Loose or unstable posts and moisture build-up at the base of posts are common causes of failure.
The rules before you build
Height limits
In England a fence can usually be up to 2 m high without planning permission, or 1 m next to a highway used by vehicles. Measure to the highest point, including the gravel board and any post caps. A 1.83 m panel on a 140 mm timber gravel board stands at about 1.97 m, but on a 300 mm concrete board it reaches about 2.13 m.
The limits do not apply if the property is a listed building or within its curtilage, if an Article 4 direction removes the right, or if a planning condition does. Ask your local planning authority if you are unsure.
Boundaries and neighbours
Build the fence wholly on your own land and check where the legal boundary runs before you dig. T marks on a title plan often indicate who maintains a boundary, but they are not always conclusive, and there is no rule that the left or right fence belongs to you. Speak to your neighbour before you start.
A gap for hedgehogs
If you can, leave a 13 cm x 13 cm gap at the bottom of the fence so hedgehogs can pass through, and ask your neighbour first if the fence is a shared boundary.
Choosing between them
Start with privacy, then weigh exposure, budget and upkeep.
If you need a solid screen, choose lap panels for a lower budget or closeboard for a stronger, longer lasting fence. If you only want to mark a boundary at the front, picket or post and rail will do. Picket fences offer little security and are not ideal for pet owners.
For an exposed garden, choose a more open style, or a closeboard frame on deep, strong posts.
Lap panels cost least. Closeboard, hit and miss and slatted styles cost more, so compare the full cost of a run, including posts, gravel boards and caps, not only the panels.
Expect to treat or stain any timber fence from time to time, and choose pressure-treated timber, especially for the posts.

